the power consumption to about one-fifth that of the standard AM26LS32, while products and disclaimers thereto appears at the end of this data sheet. Compared to the AM26LS32 and the AM26LS33, the AM26LS32A and AM26LS33A products and disclaimers thereto appears at the end of this data sheet. AM26LS32 Quad Eia/3 Line Receiver With Outputs. QUAD EIA- / Line Receiver Details, datasheet, quote on part number: AM26LS
|Published (Last):||3 December 2018|
|PDF File Size:||4.84 Mb|
|ePub File Size:||12.31 Mb|
|Price:||Free* [*Free Regsitration Required]|
Here’s the datasheet for the line receiver: Hi, I’m new here I am trying to convert the sub-outputs A high, low, B high, low of an encoder into standard Channel A and B quadrature encoder signals.
Note that my controller is designed to read the output of an HEDS which is an optical encoder with built in line receivers. Motorola Literature Distribution; P. But I am afraid of damaging my controller and I have no practical way to test that other than trial and error Basically any advice here would be really appreciated.
Motorola makes no warranty, representation or guarantee regarding the suitability of its products for any particular purpose, nor does Motorola assume any liability arising out of the application or use of any product or circuit, and specifically disclaims any and all liability, including without limitation consequential or incidental damages.
Thanks I finally was able to get my controller to read the signals. My new encoder doesn’t have these line receivers and I need to do internally before I send the output to the controller. Motorola products are not designed, intended, or authorized for use as components in systems intended for surgical implant into the body, or other applications intended to support or sustain life, or for any other application in which the failure of the Motorola product could create a situation where personal injury or death may occur.
Motorola products are not designed, intended, or authorized for use as components in. Should Buyer purchase or use Motorola products for any such unintended or unauthorized application, Buyer shall indemnify and hold Motorola and its officers, employees, subsidiaries, affiliates, and distributors harmless against all claims, costs, damages, and expenses, and reasonable attorney fees arising out of, directly or indirectly, any claim of personal injury or death associated with such unintended or unauthorized use, even if such claim alleges that Motorola was negligent regarding the design or manufacture of the part.
Motorola does not convey any license under its patent rights nor the rights of others.
Could anyone point me in the right direction? So I am looking at this datasheet and actually did some ONE test already but my signals are not they should be.
How to reach us: That datasheet didn’t have any other information and figured I’d try this mode which didn’t work an26ls32, the output signal wasn’t recognized by my controller. Motorola and are registered trademarks of Motorola, Inc. My encoder is a Maxon Motorola Electronic Components Datasheet.
Based on this datasheet, and if I had to guess I would try and put Pin4 to High and would let Pin12 floating.
Here’s what I tried. Send Bitcoin tips to: I didn’t have the complete datasheet and there was mention to put Pin4 to Low ground and Pin12 to High Vcc in order to activate the high impendance output. Motorola makes no warranty, representation or guarantee regarding.
AM26LS32 Datasheet PDF –
Should Buyer purchase or use Motorola products for any such. Box ; Phoenix, Arizona I have one more question though. Motorola reserves the right to make changes without further notice to any products herein.