The Hicom E PBX system, the new family of systems with professional phone system for small and medium enterprises. The system supports ISDN and. responsibility for errors or omissions contained herein. Configuration Note – Ver C (03/01). Siemens Hicom E/E. & Office. Enhanced DTMF In-Band. Hicom E Hicom Hicom Hicom E Hicom Hicom Hicom Hicom , Hicom , Hicom , Hicom E. Hicom E OfficePoint.
|Published (Last):||25 June 2005|
|PDF File Size:||5.18 Mb|
|ePub File Size:||14.94 Mb|
|Price:||Free* [*Free Regsitration Required]|
Thank you very much for your help.
Allocating Extensions And Actuators The classes of service correspond to the values specified in the chapter “Classes of service as of SW 2. Unrestricted trunk ac- User may telephone without any restrictions cess Table Classes of service as of SW 2.
Codes for accessing hicmo Diversion, External as Of Sw Version 2. The call forwarding timeout for this list should be set to 15 rings so that calls are not forwarded when the intercept console is functioning properly. Up to 4 entrance telephones can be connected. Page Barred numbers list 5, 10 items Barred numbers list 6, 10 items Total active exts.
Least Cost Routing lcr Page 6 allowed and 6 barred numbers 14 3 allowed numbers list lists as of SW 2.
Power supplies for Siemens Hicom 100E (108/112/118)
Page – Alerting tone during conference as of S Figure Motherboard Interfaces as Of Sw 2. Outgoing Traffic, General as Of Sw 2.
This feature can be used from the local attendant console not network-wide or from any other attendant con- sole, an attendant console group or from the night station. An additional 5 allowed and barred number lists are available with up to ten 7-digit entries as of V2. Hello colleagues, I have to operate and program hicom E, and I didn’t work with Siemens pbx before. These symbols are not usually used in the manual. Defining The Call Duration Lines in a shared basic access must always be assigned the same intercept console extension.
Behaviour In Emergencies Fax Recognition And Ddi Module This procedure lasts approx. Before commencing work on the system or installing expansions, always pull the power plug, disconnect screw connections and pull the PSU or UPS, as otherwise the modules may be damaged.
Install an S bus 100d only, no slave in Hicom E. Headset Call pickup group 1 for ext. Defining The Call Duration Sensor no. Page The connection to the entrance telephone is then to be set up by dialling the relevant code.
Caracas Desk Basic Settings e. Hico Ddi Settings The required intercept console extensions are assigned to lines 1 to 4.
The following programming procedures should be performed step by step. Changing The Currency Unit If a changed equipping scheme is detected during startup: Red Flag This Post Please let us know here why this post is inappropriate. Click Here to join Tek-Tips and talk with other members!
SIEMENS HICOM E SERVICE MANUAL Pdf Download.
Pin assignment of the printer adapter Only SLAS8 modules can be inserted in slots 1 and 2. Installing Caracas Desk Pin assignments Mini-Western sockets: For this reason, the exception table should be completed as described hocom. Table Of Contents Pin assignment of the printer adapter Page Trunk interface with analogue trunk, see Section 2.
Register now while it’s still free! The following sequence is recommended when putting the Caracas Desk into operation: Call forwarding in the exchange is only supported at extension 11 in the case of PMP.
It’s easy to join and it’s free. Page – Reference extensions Page – Normal extensions Page – Reference extensions Page – Hicm extensions Page – Dialling signal transmission mode as of Danger Page 20 – Hicom E Version 2.